[Lab] Laser cutter status?

[Darcy Whyte]

That's what I just said. :)



--
Darcy Whyte

Software Since '88 siteware.com | Contact: darcy at siteware.com |
613-563-3634 by appointment

Canada N 45° 25'03.1" W 75° 42'21.4"
Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
rubber-power.com



On Sun, Jan 4, 2015 at 5:51 PM, <janick at bergeron.com> wrote:

>  Printing direct from InkScape does not work. Must save as PDF then print
> that.
>
> I always bring both PDF and SVG on a USB stick in case I need to make
> adjustments on site. Not much point bringing my laptop if the application
> is installed on that PC.
>
>
>
>
> On 2015-01-04 17:24, Andrew Barbour wrote:
>
> Does anyone print direct from their design application on their laptop vs
> USB key on the old PC in the lab?  If so - is it easier than moving files
> to the dedicated PC?  Any issues??
>
> On Sun, Jan 4, 2015 at 3:06 PM, <janick at bergeron.com> wrote:
>
>>  Correction: Left side! Add the margin on the left side!
>>
>>
>>
>>
>> On 2015-01-04 14:45, janick at bergeron.com wrote:
>>
>> I swung by yesterday and it is still not fixed.
>>
>> It is still usable if you:
>>
>> - Add a 1" margin on the right side of your design
>>
>> - Place your material 2-3/4" down
>>
>> - Print without any centering
>>
>> - Have a lot of patience
>>
>>
>>
>>
>> On 2015-01-04 14:38, John Doe wrote:
>>
>>  I haven't heard anything for a while, does anybody know the current
>> status of the laser cutter?
>>
>> Thanks,
>> Mark Smith
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca to send your message to the list
>>
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca to send your message to the list
>>
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca to send your message to the list
>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150104/7e2304a3/attachment.html>