[Lab] Laser cutter status?

[janick at bergeron.com]

Printing direct from InkScape does not work. Must save as PDF then print
that. 

I always bring both PDF and SVG on a USB stick in case I need to make
adjustments on site. Not much point bringing my laptop if the
application is installed on that PC. 

On 2015-01-04 17:24, Andrew Barbour wrote: 

> Does anyone print direct from their design application on their laptop vs USB key on the old PC in the lab? If so - is it easier than moving files to the dedicated PC? Any issues?? 
> 
> On Sun, Jan 4, 2015 at 3:06 PM, <janick at bergeron.com> wrote:
> 
> Correction: Left side! Add the margin on the left side! 
> 
> On 2015-01-04 14:45, janick at bergeron.com wrote: 
> 
> I swung by yesterday and it is still not fixed. 
> 
> It is still usable if you: 
> 
> - Add a 1" margin on the right side of your design 
> 
> - Place your material 2-3/4" down 
> 
> - Print without any centering 
> 
> - Have a lot of patience 
> 
> On 2015-01-04 14:38, John Doe wrote: 
> 
> I haven't heard anything for a while, does anybody know the current status of the laser cutter? 
> 
> Thanks,
> Mark Smith 
> 
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab [1]
> 2. then email Lab at artengine.ca to send your message to the list
> 
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab [1]
> 2. then email Lab at artengine.ca to send your message to the list

_______________________________________________
 Lab mailing list
 1. subscribe http://artengine.ca/mailman/listinfo/lab [1]
 2. then email Lab at artengine.ca to send your message to the list 

Links:
------
[1] http://artengine.ca/mailman/listinfo/lab
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150104/3e7d6ab0/attachment.html>