[Lab] Laser cutter status?

[Andrew Barbour]

Does anyone print direct from their design application on their laptop vs
USB key on the old PC in the lab?  If so - is it easier than moving files
to the dedicated PC?  Any issues??

On Sun, Jan 4, 2015 at 3:06 PM, <janick at bergeron.com> wrote:

>  Correction: Left side! Add the margin on the left side!
>
>
>
>
> On 2015-01-04 14:45, janick at bergeron.com wrote:
>
> I swung by yesterday and it is still not fixed.
>
> It is still usable if you:
>
> - Add a 1" margin on the right side of your design
>
> - Place your material 2-3/4" down
>
> - Print without any centering
>
> - Have a lot of patience
>
>
>
>
> On 2015-01-04 14:38, John Doe wrote:
>
>  I haven't heard anything for a while, does anybody know the current
> status of the laser cutter?
>
> Thanks,
> Mark Smith
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150104/470dfe1f/attachment.html>