[Lab] Laser cutter status?

[janick at bergeron.com]

Correction: Left side! Add the margin on the left side! 

On 2015-01-04 14:45, janick at bergeron.com wrote: 

> I swung by yesterday and it is still not fixed. 
> 
> It is still usable if you: 
> 
> - Add a 1" margin on the right side of your design 
> 
> - Place your material 2-3/4" down 
> 
> - Print without any centering 
> 
> - Have a lot of patience 
> 
> On 2015-01-04 14:38, John Doe wrote: 
> 
>> I haven't heard anything for a while, does anybody know the current status of the laser cutter? 
>> 
>> Thanks,
>> Mark Smith 
>> 
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab [1]
>> 2. then email Lab at artengine.ca to send your message to the list
> 
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab [1]
> 2. then email Lab at artengine.ca to send your message to the list
 

Links:
------
[1] http://artengine.ca/mailman/listinfo/lab
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150104/680f97e7/attachment.html>