[Lab] Laser update

[Richard Sloan]

Hope that is it, but my gut feel is that it won't be, I think it's more the
end stop sensor, unless it's a bad input on the controller for that end
stop... just does not feel like a controller issue.  Hope manufacturer is
right, one hell of a price to pay if they are wrong.

Richard.
On 2014-11-25 10:40 AM, "Remco Volmer" <programming at artengine.ca> wrote:

> Hi all,
>
> After lengthy conversations with the manufacturer, the current
> solution is to replace the entire controller pad. A new one has been
> ordered and should arrive this week. Thank you for your patience.
>
> Remco
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141125/641d2a8f/attachment.html>