[Lab] Laser update

[greg atcheson]

Can't you just open it up and do some troubleshooting or is it under
warranty?
On Nov 25, 2014 9:40 PM, "Richard Sloan" <rsloan at themindfactory.com> wrote:

> Hope that is it, but my gut feel is that it won't be, I think it's more
> the end stop sensor, unless it's a bad input on the controller for that end
> stop... just does not feel like a controller issue.  Hope manufacturer is
> right, one hell of a price to pay if they are wrong.
>
> Richard.
> On 2014-11-25 10:40 AM, "Remco Volmer" <programming at artengine.ca> wrote:
>
>> Hi all,
>>
>> After lengthy conversations with the manufacturer, the current
>> solution is to replace the entire controller pad. A new one has been
>> ordered and should arrive this week. Thank you for your patience.
>>
>> Remco
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca to send your message to the list
>>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141125/2f92350f/attachment.html>