[Lab] laser status
technical at artengine.ca
Thu Aug 21 10:14:37 EDT 2014
I used the cutter last week with no problem, but someone had reported an
issue a few days earlier. I'm going into the lab to play with it in a
On Thursday, August 21, 2014, Darcy Whyte <darcy at inventorartist.com> wrote:
> Okay, so the problem is not new. Anybody else notice anything?
> I suppose the next thing to do is get the manufacturer support on the line
> and see if they have anything in their help database on it.
> Last night when a bunch of people were all around it the firmware was
> reflashed but that didn't seem to affect the problem.
> Darcy Whyte
> Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
> Contact: darcy at inventorArtist.com
> by appointment (no text)
> On Thu, Aug 21, 2014 at 10:03 AM, Andrew Szeto <andrew.szeto at outlook.com
>> Hey Darcy,
>> I noticed what you were describing last week when I used it. First time
>> it's happened to me. It would re-position itself after I had it placed (xy
>> off) and hit the "Go" button for the first time (*second time is when it
>> actually started its cuts). My work around was to then re-adjust my project
>> to where the machine had re-positioned itself to. I generally start my cuts
>> from left-center, so it wasn't too much of an ordeal. It's not ideal, but
>> it worked out alright. Sorry I didn't report this earlier. I didn't perform
>> any actions that were out of the ordinary (to my knowledge anyhow), so I
>> don't think I prompted it to act that way. Hopefully we can get this
>> resolved. Here to help in any way possible.
>> From: darcy at inventorArtist.com
>> Date: Thu, 21 Aug 2014 09:56:00 -0400
>> Subject: [Lab] laser status
>> I noticed last night when I was called to help with the laser that it's
>> acting out. Just after setting home it is going through some routine moving
>> the head around and then arriving back near home.
>> Did this problem just occur last night? It is helpful if people come
>> forward when problems are noticed so anybody investigating can know the
>> entire history of the problem. For instance if there was any attempts at
>> resolving a problems, what was it and what was the outcome. What was going
>> on when the problem occurred and so forth.
>> What is the status of the machine now? Is it working?
>> Darcy Whyte
>> Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
>> Contact: darcy at inventorArtist.com
>> by appointment (no text)
>> _______________________________________________ Lab mailing list 1.
>> subscribe http://artengine.ca/mailman/listinfo/lab 2. then email
>> send your message to the list
*Technical Coordinator *
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab