[Lab] laser status

[Darcy Whyte]

Okay, so the problem is not new. Anybody else notice anything?

I suppose the next thing to do is get the manufacturer support on the line
and see if they have anything in their help database on it.

Last night when a bunch of people were all around it the firmware was
reflashed but that didn't seem to affect the problem.



--
Darcy Whyte

Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
rubber-power.com
Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)



On Thu, Aug 21, 2014 at 10:03 AM, Andrew Szeto <andrew.szeto at outlook.com>
wrote:

> Hey Darcy,
>
> I noticed what you were describing last week when I used it. First time
> it's happened to me. It would re-position itself after I had it placed (xy
> off) and hit the "Go" button for the first time (*second time is when it
> actually started its cuts). My work around was to then re-adjust my project
> to where the machine had re-positioned itself to. I generally start my cuts
> from left-center, so it wasn't too much of an ordeal. It's not ideal, but
> it worked out alright. Sorry I didn't report this earlier. I didn't perform
> any actions that were out of the ordinary (to my knowledge anyhow), so I
> don't think I prompted it to act that way. Hopefully we can get this
> resolved. Here to help in any way possible.
>
> Cheers,
> Andrew
>
>
>
>
> ------------------------------
> From: darcy at inventorArtist.com
> Date: Thu, 21 Aug 2014 09:56:00 -0400
> To: lab at artengine.ca
> Subject: [Lab] laser status
>
>
> I noticed last night when I was called to help with the laser that it's
> acting out. Just after setting home it is going through some routine moving
> the head around and then arriving back near home.
>
> Did this problem just occur last night? It is helpful if people come
> forward when problems are noticed so anybody investigating can know the
> entire history of the problem. For instance if there was any attempts at
> resolving a problems, what was it and what was the outcome. What was going
> on when the problem occurred and so forth.
>
> What is the status of the machine now? Is it working?
>
>
> --
> Darcy Whyte
>
> Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
> rubber-power.com
> Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)
>
>
> _______________________________________________ Lab mailing list 1.
> subscribe http://artengine.ca/mailman/listinfo/lab 2. then email
> Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20140821/4499a50f/attachment.html>