[Lab] laser venting

[Darcy Whyte]

My suggestion was just to move it. Should take 10 m.
On Jul 9, 2013 10:54 AM, "Britta Evans-Fenton" <technical at artengine.ca>
wrote:

> Thanks for the concerns everyone. I have booked the laser off for
> Maintenance until the rest of the month.  I'm working with a group who has
> planned to install the laser into the other room, in early August.
>
> I will give you any updates that I receive.
>
> If you have any questions, please don't hesitate to email me directly,
>
>
> Britta
> *Technical Coordinator *
> Artengine.ca
>
> Ottawa Mini Maker Faire
> Aug. 31 & Sept. 1 2013
> www.makerfaireottawa.com
> @MakerFaireOTT
> #MMFO
>
>
> On Sun, Jul 7, 2013 at 9:31 PM, Kyle Chisholm <kyle.chisholm2 at gmail.com>wrote:
>
>> I just used the laser cutter this morning. The system was working fine
>> for awhile but the filter did start beeping after a few cuts and stopped
>> pulling the air through (I assume this is the overheating issue mentioned
>> previously). I stopped cutting and turned on the small fan but didn't
>> realize it was to cool the motors. Anyways, yes it was smokey in there and
>> a window would be great!
>> Kyle
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca
>>
>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20130709/690cef12/attachment.html>