[Lab] laser venting

[Britta Evans-Fenton]

I still have to clear up some stuff before we can more it.


Britta
*Technical Coordinator *
Artengine.ca

Ottawa Mini Maker Faire
Aug. 31 & Sept. 1 2013
www.makerfaireottawa.com
@MakerFaireOTT
#MMFO


On Tue, Jul 9, 2013 at 12:00 PM, Darcy Whyte <darcy at siteware.com> wrote:

> My suggestion was just to move it. Should take 10 m.
> On Jul 9, 2013 10:54 AM, "Britta Evans-Fenton" <technical at artengine.ca>
> wrote:
>
>> Thanks for the concerns everyone. I have booked the laser off for
>> Maintenance until the rest of the month.  I'm working with a group who has
>> planned to install the laser into the other room, in early August.
>>
>> I will give you any updates that I receive.
>>
>> If you have any questions, please don't hesitate to email me directly,
>>
>>
>> Britta
>> *Technical Coordinator *
>> Artengine.ca
>>
>> Ottawa Mini Maker Faire
>> Aug. 31 & Sept. 1 2013
>> www.makerfaireottawa.com
>> @MakerFaireOTT
>> #MMFO
>>
>>
>> On Sun, Jul 7, 2013 at 9:31 PM, Kyle Chisholm <kyle.chisholm2 at gmail.com>wrote:
>>
>>> I just used the laser cutter this morning. The system was working fine
>>> for awhile but the filter did start beeping after a few cuts and stopped
>>> pulling the air through (I assume this is the overheating issue mentioned
>>> previously). I stopped cutting and turned on the small fan but didn't
>>> realize it was to cool the motors. Anyways, yes it was smokey in there and
>>> a window would be great!
>>> Kyle
>>> _______________________________________________
>>> Lab mailing list
>>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>>> 2. then email Lab at artengine.ca
>>>
>>
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20130709/9f3d9de6/attachment.html>