[Lab] 1.75mm or 3mm for extruding

[Darcy Whyte]

I just grabbed the 3mm extruder.

I'll go get it on the next trip to New York (which looks like it's the next
weekend (after this one)).





On Fri, Jan 21, 2011 at 8:51 AM, Darcy Whyte <darcy at siteware.com> wrote:

> So you're saying that the source filament affects the precision?
>
>
>    -  Stepper Plastruder Kit -Batch 5 (.35mm hybrid for 1.75mm filament) -
>    Complete for Cupcake/ToM or Mendel (Pre-Order) for $165.00 USD
>    -  Stepper Plastruder Kit - Batch 5 (.35mm hybrid for 3mm filament) -
>    Complete for Cupcake/ToM or Mendel (Pre-Order) for $165.00 USD
>
>
>
>
>
>
> On Thu, Jan 20, 2011 at 8:54 PM, Tom Burns <tom.i.burns at gmail.com> wrote:
>
>> if you need the higher resolution for your parts
>>
>>
>> On Thu, Jan 20, 2011 at 8:37 PM, Darcy Whyte <darcy at siteware.com> wrote:
>>
>>> Thanks
>>> Can you think of a reason to get the smaller extruder?
>>>
>>> On Jan 20, 2011 7:05 PM, "Andrew Plumb" <andrew at plumb.org> wrote:
>>>
>>> It's 3mm filament at present.
>>>
>>> A.
>>>
>>> On 2011-01-20, at 6:27 PM, Darcy Whyte wrote:
>>>
>>> > Does the makerbot in M70 use 1.75mm or 3mm plastic? > >
>>> _______________________________________________
>>> Lab mailing list
>>> Lab at artengine.ca
>>> http://artengine.ca/mailman/listinfo/lab
>>>
>>>
>>>  --
>>>
>>> Makerbot Number Nine... #9... 0x09... 0o11... 0b1001...
>>> http://clothbot.com/wiki/MakerBotNumberNine
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> Lab mailing list
>>> Lab at artengine.ca
>>> http://artengine.ca/mailman/listinfo/lab
>>>
>>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20110121/a690e872/attachment.htm>