[Lab] 1.75mm or 3mm for extruding

[Darcy Whyte]

So you're saying that the source filament affects the precision?


   -  Stepper Plastruder Kit -Batch 5 (.35mm hybrid for 1.75mm filament) -
   Complete for Cupcake/ToM or Mendel (Pre-Order) for $165.00 USD
   -  Stepper Plastruder Kit - Batch 5 (.35mm hybrid for 3mm filament) -
   Complete for Cupcake/ToM or Mendel (Pre-Order) for $165.00 USD






On Thu, Jan 20, 2011 at 8:54 PM, Tom Burns <tom.i.burns at gmail.com> wrote:

> if you need the higher resolution for your parts
>
>
> On Thu, Jan 20, 2011 at 8:37 PM, Darcy Whyte <darcy at siteware.com> wrote:
>
>> Thanks
>> Can you think of a reason to get the smaller extruder?
>>
>> On Jan 20, 2011 7:05 PM, "Andrew Plumb" <andrew at plumb.org> wrote:
>>
>> It's 3mm filament at present.
>>
>> A.
>>
>> On 2011-01-20, at 6:27 PM, Darcy Whyte wrote:
>>
>> > Does the makerbot in M70 use 1.75mm or 3mm plastic? > >
>> _______________________________________________
>> Lab mailing list
>> Lab at artengine.ca
>> http://artengine.ca/mailman/listinfo/lab
>>
>>
>>  --
>>
>> Makerbot Number Nine... #9... 0x09... 0o11... 0b1001...
>> http://clothbot.com/wiki/MakerBotNumberNine
>>
>>
>>
>>
>> _______________________________________________
>> Lab mailing list
>> Lab at artengine.ca
>> http://artengine.ca/mailman/listinfo/lab
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20110121/eaca7d3f/attachment.htm>