[Lab] 1.75mm or 3mm for extruding

[Tom Burns]

if you need the higher resolution for your parts

On Thu, Jan 20, 2011 at 8:37 PM, Darcy Whyte <darcy at siteware.com> wrote:

> Thanks
> Can you think of a reason to get the smaller extruder?
>
> On Jan 20, 2011 7:05 PM, "Andrew Plumb" <andrew at plumb.org> wrote:
>
> It's 3mm filament at present.
>
> A.
>
> On 2011-01-20, at 6:27 PM, Darcy Whyte wrote:
>
> > Does the makerbot in M70 use 1.75mm or 3mm plastic? > >
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab
>
>
>  --
>
> Makerbot Number Nine... #9... 0x09... 0o11... 0b1001...
> http://clothbot.com/wiki/MakerBotNumberNine
>
>
>
>
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20110120/a694a5d7/attachment.htm>