[Lab] question for a 3d printing software....

[Dave Hunt]

it really depends on what you want to draw.  Tinkercad has a very simple
interface.  Blender is a great tool but has a steeper learning curve.  Also
don't forget abode the Adobe 123D suite of free products.
http://www.123dapp.com/create


On Tue, Sep 22, 2015 at 10:26 PM, benoit gauthier <benoit1975 at hotmail.ca>
wrote:

> Or tinkercad ?
>
> Thanx
>
> ------------------------------
> From: benoit1975 at hotmail.ca
> To: lab at artengine.ca
> Date: Tue, 22 Sep 2015 20:39:14 -0400
> Subject: [Lab] question for a 3d printing software....
>
> Ok my school is in to buy a 3d printer but which software we should use :
> Blender or sketchup with susolid ?  If you could give me advice on cost, if
> it's easy to use etc....
>
> Thanx,
>
> Benoit
>
> _______________________________________________ Lab mailing list 1.
> subscribe http://artengine.ca/mailman/listinfo/lab 2. then email
> Lab at artengine.ca to send your message to the list
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150923/028e8f40/attachment.html>