[Lab] Zing 24 analysis

[Stephen Burke]

According to the tech support at Epilog, and based upon all the testing/servicing they had me do, there are two components that would be most likely the cause of the problem.

sensor board (75%)
sensor cable (20%)

The sensor cable connects the sensor board to a control board.  There is only a 5% chance that it is the control board.  Of course, you have to change the sensor board and cable first to determine if it is the control board.

I have submitted a quote to Artengine; if accepted the parts will be ordered ASAP and the unit could be fully operational by September 25th.  Again, this all depends on the diagnosis being correct.


Stephen Burke
Account Executive
Envirolaser Ltd.

613-619-1013 cell
613-225-4726 office
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150901/515105af/attachment.html>