[Lab] Laser update

[Henri K]

Thanks Richard,

all good points. i tried before lowering the bed all the way to the ground as well without success. if all fails, shimming it is.


Cheers,
Henri Kuschkowitz

On November 25, 2014 at 11:34:48 PM, Darcy Whyte (darcy at inventorartist.com) wrote:

I poked by on my way out to a social this evening and looked at the bed. There was some poopie in one of the holes in the fixture. Here's a picture of the one right by the exhaust port. I checked bed alignment after that and it seemed okay.

Trick is once you focus, move the focus gauge to the corners of your work area to make sure you're level enough..If not, shim the work piece or check under the tray...

The fixture is badly designed on this machine for this problem... 

Oh, there's another thing.. the way it's designed it's easy to put the cutting grid on with only the top left feet in the fixture....

 


--
Darcy Whyte

Art+ inventorArtist.com | Aviation rubber-power.com
Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)





On Tue, Nov 25, 2014 at 9:40 PM, Richard Sloan <rsloan at themindfactory.com> wrote:
Hope that is it, but my gut feel is that it won't be, I think it's more the end stop sensor, unless it's a bad input on the controller for that end stop... just does not feel like a controller issue.  Hope manufacturer is right, one hell of a price to pay if they are wrong.

Richard.

On 2014-11-25 10:40 AM, "Remco Volmer" <programming at artengine.ca> wrote:
Hi all,

After lengthy conversations with the manufacturer, the current
solution is to replace the entire controller pad. A new one has been
ordered and should arrive this week. Thank you for your patience.

Remco

_______________________________________________
Lab mailing list
1. subscribe http://artengine.ca/mailman/listinfo/lab
2. then email Lab at artengine.ca to send your message to the list

_______________________________________________
Lab mailing list
1. subscribe http://artengine.ca/mailman/listinfo/lab
2. then email Lab at artengine.ca to send your message to the list

_______________________________________________  
Lab mailing list  
1. subscribe http://artengine.ca/mailman/listinfo/lab  
2. then email Lab at artengine.ca to send your message to the list
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141126/14229730/attachment.html>