[Lab] Higher speed (8.0 Mbps) I/O interface with PC

[Jean-Marc LeBlanc]

you could always try with
http://www.sparkfun.com/datasheets/DevTools/WIZnet/DEV-09473-Datasheet_V_1.1.pdf
http://www.sparkfun.com/products/9473

the ftdi chip (serial to usb on arduino) only goes to 1megabaud so I
don;t think that works.

Jean-Marc Le Blanc
---

"Do you pine for the nice days of Minix-1.1, when men were men and
wrote their own device drivers?" Linus Torvalds




On Fri, Feb 11, 2011 at 6:56 PM, Dwayne C. Litzenberger <dlitz at dlitz.net> wrote:
> Does anybody know how to get 8 Mbps into a PC from a relatively dumb
> circuit?
>
> I have a Xilinx FPGA development board, and I'd like to get data into and
> out of it at these high speeds without having to do the work of setting up a
> soft CPU or an Ethernet MAC.
>
> --
> Dwayne C. Litzenberger <dlitz at dlitz.net>
>  OpenPGP: 19E1 1FE8 B3CF F273 ED17  4A24 928C EC13 39C2 5CF7
>
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab
>