[Lab] Envirolaser & Dremel

[Stephen Burke]

Hello Alyssa,

The Dremel DigiLab LC40 is the result of a cooperative project with Full 
Spectrum Laser.  The LC40 is essentially the same device as the Muse.

The laser cutter has a 20" x 12" work area, allowing the laser cutter to 
fit on most desktops.

In a typical configuration, the laser cutter will vent to the exterior 
of the building, without any filtration.  For locations that can't 
modify walls or windows for an external exhaust, a selection of external 
filter boxes are available from Full Spectrum Laser via Envirolaser.

The Hex Box is a combination of air assist and water cooler.

Here's the page link for the Muse:  https://fslaser.com/Muse

Here's the page link for the LC40: 
https://digilab.dremel.com/products/lc40-laser-cutter

I have to speak with my Full Spectrum Laser rep to confirm, but it looks 
like Muse accessories should be compatible with the LC40.


Stephen Burke
Account Executive
Envirolaser Ltd.

613-225-4726 Ottawa Local
613-619-1013 Mobile
800-565-9156 Toll Free

On 14/06/2018 12:00 PM, lab-request at artengine.ca wrote:
> Send Lab mailing list submissions to
> 	lab at artengine.ca
>
> To subscribe or unsubscribe via the World Wide Web, visit
> 	https://artengine.ca/mailman/listinfo/lab
> or, via email, send a message with subject or body 'help' to
> 	lab-request at artengine.ca
>
> You can reach the person managing the list at
> 	lab-owner at artengine.ca
>
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of Lab digest..."
>
>
> Today's Topics:
>
>     1. Envirolaser & Dremel (Stephen Burke)
>     2. Re: Envirolaser & Dremel (Alyssa P Hacker)
>
>
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> https://artengine.ca/mailman/listinfo/lab

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://artengine.ca/pipermail/lab/attachments/20180614/6417fb3b/attachment.html>