[Lab] Zing 24 performance issue

[Britta Evans-Fenton]

Hey guys,

I'm pretty sure I solved the problem. I've been talking with the epilog
guys, and there was a miscommunication with Remco on what needed to be
replayed. We got the part shipped in and we are only waiting to rehook up
the laser to a filter system before we can use it again to test it out.

Assuming Remco still needs help on this, can someone help hook the laser up
to the filter? I know we have changed the filter around, so Doug should be
involved in some way.

Cheers,

*Britta Evans-Fenton*
Cultural Producer

Call for Maker is now OPEN!
*makerfaireottawa.com/ <http://makerfaireottawa.com/>*
Early Bird Deadline: Sept 1st

On Wed, Sep 2, 2015 at 10:15 AM, Stephen Burke <steve at envirolaser.com>
wrote:

> The easiest way I can describe the problem is that the Zing 24 doesn't
> "home to origin" properly.  That is to say, if you position the gantry to
> any position that is not the home position when the power is off, and power
> on, the gantry is supposed to move to the rear of the unit with the head at
> the back left corner.  At this point in time, it doesn't do that.
>
> This indicates a problem with the Y axis control, most likely due to a
> sensor malfunction or a sensor cable that is damaged.
>
>
> Stephen Burke
> Account Executive
> Envirolaser Ltd.
>
> 613-619-1013 cell
> 613-225-4726 office
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20150902/08b05daf/attachment.html>