[Lab] rastering with laser

[Darcy Whyte]

You can see how I'm doing vector cutting here...

http://inventorartist.com/tool-chains/

For raster you just have any shape and it should raster. But it's just
experimental. You need to try stuff as material and machines aren't that
consistent...



--
Darcy Whyte

Software Since '88 siteware.com | Contact: darcy at siteware.com |
613-563-3634 by appointment

Canada N 45° 25'03.1" W 75° 42'21.4"
Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
rubber-power.com



On Tue, Oct 7, 2014 at 4:40 PM, Jason Arnold <arnold.jason at gmail.com> wrote:

> Hi all,
>
> I've got some shapes I'll be cutting in acrylic later today (see attached)
> that need some "fill" (aka raster), which I've never done before on the
> Epilog. Can someone write me a quick how to?
>
> I've been told I can also just leave it as vector and use a lower power -
> any pros or cons would be appreciated.
>
> In case it matters, the fill is the red areas and end result is that these
> will be edge lit (hence the LED sized notches in the base).
>
> *Jason*
>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141007/04f12bd3/attachment.html>