[Lab] ESP8266 Issues...

[Richard Sloan]

Sorry I thought this message came through my esp8266.com email, its on the
lab list!

brain dead!

depends on the code version some worked on 115200 57600 and 9600, but it
seems your ok...

the ESP8266 is 3.3V are you using a 5V arduino? this is a no-no!

R.

On Mon, Nov 24, 2014 at 7:40 PM, greg atcheson <greg.atcheson at gmail.com>
wrote:

> This might be totally useless, but on a Bluetooth module I used you have
> to enter a key sequence to enter command mode. (--- for what it's worth).
> Datasheet might barely mention it.
> On Nov 24, 2014 6:24 PM, "Adrian Jones" <adrian at woodsgood.ca> wrote:
>
>> Hi all,
>> I just started playing with the ESP8266 WiFi Module.
>> I have CoolTerm open at 115200 and when I cycle the CH_PD line to Vcc, it
>> spits out tons of the following. However, even though I see the light
>> flash
>> momentarily, the module does not respond to any AT commands...
>>
>> Any suggestions?
>>
>>
>> ets Jan  8 2013,rst cause:4, boot mode:(3,6)
>>
>> wdt reset
>> load 0x40100000, len 25052, room 16
>> tail 12
>> chksum 0x0b
>> ho 0 tail 12 room 4
>> load 0x3ffe8000, len 3312, room 12
>> tail 4
>> chksum 0x53
>> load 0x3ffe8cf0, len 6576, room 4
>> tail 12
>> chksum 0x0d
>> csum 0x0d
>> Fatal exception (0):
>> epc1=0x402485e1, epc2=0x00000000, epc3=0x00000000, excvaddr=0x00000000,
>> depc=0x00000000
>>
>>  ets Jan  8 2013,rst cause:4, boot mode:(3,6)
>>
>> wdt reset
>> load 0x40100000, len 25052, room 16
>> tail 12
>> chksum 0x0b
>> ho 0 tail 12 room 4
>> load 0x3ffe8000, len 3312, room 12
>> tail 4
>> chksum 0x53
>> load 0x3ffe8cf0, len 6576, room 4
>> tail 12
>> chksum 0x0d
>> csum 0x0d
>>
>>
>> Many thanks,
>>
>> .... Adrian
>>
>>
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca to send your message to the list
>>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141124/1da398c9/attachment.html>