[Lab] Laser not working

[Andrew Barbour]

I found the issue surfaced its head when i tried to pause while the cutter
was in the middle of a job.  Everything was working fine.... then bam.
Ha4d shut down with the computer disconnected, reset the home, and it was
good to go......

As a side note.... it seems pretty dirty... I do the required end of kob
cleaning but thw amount of dust/residue on the moving parts is crazy.
Maybe we should arrange a cleaning day and do all the cleaning tasks that
are ok for a non repair/warranty tech to do......  Bring it into the main
room and give it a good cleaning?? Remco??
On Nov 17, 2014 11:35 AM, "Andrew Szeto" <andrew.szeto at outlook.com> wrote:

> Hey Folks,
>
> I dropped by last night and it appears to have the exact same issue it had
> previously. I am thinking whatever the fix was last time (new firmware?),
> should hopefully fix it this time too. If it's something that members can
> hopefully implement ourselves when it arises, that would be helpful.
>
> Thanks y'all!
> Andrew
>
>
>
>
> ------------------------------
> From: jweisberg at sympatico.ca
> To: lab at artengine.ca
> Date: Mon, 17 Nov 2014 11:29:54 -0500
> Subject: Re: [Lab] Laser not working
>
> For some reason the text of my previous message didn't show. Here it is.
>
> Hi,
> The home setting on the laser is not working properly. It seems set a few
> inches in from the back of the table, and the carriage is hitting the
> ‎front stops as a result, when cutting larger pieces. I checked the manual
> and tried a few different user settings without success. May need to go
> into the configuration menu to reset X and Y.
> Also the duct w/fan to the left of the laser has fallen apart. I didn't
> have time or materials to fix it either.
> John
>
>
> _______________________________________________ Lab mailing list 1.
> subscribe http://artengine.ca/mailman/listinfo/lab 2. then email
> Lab at artengine.ca to send your message to the list
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141117/630d5b2b/attachment.html>