[Lab] Does any one have

[Jim Kiskis]

 This is a one off to see if it would meet my needs as I need to control a dc charger for my e-bike 
So it will be on and off during the low cost times for charging as the ones I have tried from retail just fail on me 

Sent from my iPad

> On Jan 26, 2014, at 7:20 PM, Roman Gargulak <roman at cncwings.com> wrote:
> 
> If you are building switched power bar similar to PowerSwitch Tail or the one in the link posted by Justin, be careful as you are dealing with lethal voltages.
> You may consider power outlet like this for your project:
> <http://www.homedepot.ca/product/decora-usb-charger-21a-with-tamper-resistant-receptacle-15a-125v-in-white/809958>
> It will give you also 2x 2.1A at 5VDC.
> 
> Just a side note, in Canada, the Canadian Electrical Code requires manufacturers or importers of electrical products to get them “approved” for electrical safety.
> This is usually done by CSA or UL (or other approved certification body) for large quantities, or Special Inspection Service can be done for small quantities or individual one-of projects.
> Any "appliance" without this certification or approval is illegal and shall not be connected to the utility power grid.
> If, God forbid, such appliance causes damage, injury or death, no insurance will cover these damages and installer of such appliance bears full liability.
> 
> Stay safe!
> 
> Roman
> 
> 
>> On 1/26/2014 4:43 PM, Jim Kiskis wrote:
>> A arduino that they might spare for purchase as I am wanting to make a power switcher from justin's previous  post
>> 
>> Jim
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca to send your message to the list
>> 
>> 
> 
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list