[Lab] cd fixture for cnc

[Darcy Whyte]

I never bothered with all that complexity. I just did this:
http://inventorartist.com/cutting-cds/




--
Darcy Whyte

Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
rubber-power.com
Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)


On Sat, Dec 27, 2014 at 11:52 AM, Darcy Whyte <darcy at inventorartist.com>
wrote:

> I might have an idea for this. Clam them from the bottom so there'll be
> nothing protruding upward.
>
> I'll make a circle that's a bit smaller than the cd and mount it. The cd
> will go under it and a lift will press it against the circle from the
> bottom... I'll need to think about this some more but I think that will
> make a better record fixture as well...
>
>
>
> --
> Darcy Whyte
>
> Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
> rubber-power.com
> Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)
>
>
> On Wed, Dec 24, 2014 at 2:34 PM, Darcy Whyte <darcy at inventorartist.com>
> wrote:
>
>> Any ideas on how to make a fixture for cutting CDs?
>> http://inventorartist.com/cutting-cds/
>>
>>
>>
>> --
>> Darcy Whyte
>>
>> Art+ inventorArtist.com <http://inventorartist.com/> | Aviation
>> rubber-power.com
>> Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141230/6bc03bc5/attachment.html>