[Lab] Router Table + Router

[matthias wandel]

A table saw will do the job much quicker and cleaner.  And a lot more people have table saws than tilting router tables.
  ----- Original Message ----- 
  From: Marinus Swanepoel 
  To: lab 
  Sent: Sunday, November 24, 2013 12:46 PM
  Subject: [Lab] Router Table + Router


  Hi,


  I would like to cut a few panels of 0.25" fiber board with a bevel of 21°. Where would I be able to access a router table, router, and router bit to make such a bevel?


  The panels will likely be about 5" square, and I would like to bevel 3 edges. I will have about 20 to 40 panels. I do not expect that routing the edges would take very long.


  If anyone is able to help I will be very appreciative.


  Thank you


  Marinus Swanepoel
  Interactive Multimedia Developer
  Phone: 613-915-0027


------------------------------------------------------------------------------


  _______________________________________________
  Lab mailing list
  1. subscribe http://artengine.ca/mailman/listinfo/lab
  2. then email Lab at artengine.ca to send your message to the list
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20131124/2201f375/attachment.html>