[Lab] Router Table + Router

[Marinus Swanepoel]

Hi,

I would like to cut a few panels of 0.25" fiber board with a bevel of 21°.
Where would I be able to access a router table, router, and router bit to
make such a bevel?

The panels will likely be about 5" square, and I would like to bevel 3
edges. I will have about 20 to 40 panels. I do not expect that routing the
edges would take very long.

If anyone is able to help I will be very appreciative.

Thank you

Marinus Swanepoel
Interactive Multimedia Developer
Phone: 613-915-0027
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20131124/bc16e64e/attachment.html>