[Lab] FabFont, a Typeface for Lasercut Stencils (CC By-SA 3.0 licensed)

[Darcy Whyte]

That's pretty nice. There's even a descent @ sign.





--
Darcy Whyte

Art+ inventorArtist.com | Aviation rubber-power.com | Software Since '88
siteware.com | Contact: darcy at siteware.com | 613-563-3634 by appointment |
Canada N 45° 25'03.1" W 75° 42'21.4"




On Mon, May 27, 2013 at 9:53 AM, Andrew Plumb <andrew at plumb.org> wrote:

> Just spotted this in my Feedly:
>
> http://moderndevice.com/resources/fabfont-a-typeface-for-lasercut-stencils/
>
> http://fablabjapan.org/recipe/recipe/fabfont/
>
> It's CC By-SA 3.0 licensed so definitely one to install on the ArtEngine
> systems.
>
> Andrew.
>
> --
>
> "The future is already here.  It's just not very evenly distributed" --
> William Gibson
>
> Me: http://clothbot.com/wiki/
>
>
>
>
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20130527/d42beef2/attachment.html>