[Lab] copper wire

[Darcy Whyte]

I ordered wire.



--
Darcy Whyte

Art+ inventorArtist.com | Aviation rubber-power.com | Software Since '88
siteware.com | Contact: darcy at siteware.com | 613-563-3634 by appointment |
Canada N 45° 25'03.1" W 75° 42'21.4"




On Fri, Jun 14, 2013 at 3:11 PM, Britta Evans-Fenton <technical at artengine.ca
> wrote:

> Is this in the tool box in the closet?  Because that would belong to our
> programming.  If it is a tool box outside of that, I'd have to investigate.
>
> Britta
>
>
> On Fri, Jun 14, 2013 at 2:41 PM, Dave Hunt <dave at huntgang.com> wrote:
>
>>  I can't recall but seem to remember thinking I had seen magnet wire in
>> there? Certainly not mine though.
>>
>>
>>
>> -------- Original message --------
>> From: Darcy Whyte <darcy at siteware.com>
>> Date:
>> To: lab <lab at artengine.ca>
>> Subject: [Lab] copper wire
>>
>>
>>  I noticed some copper wire in the red tool box. Is anybody using it?
>> Does anybody know what gauge it is?
>>
>>
>>
>>  --
>> Darcy Whyte
>>
>>  Art+ inventorArtist.com | Aviation rubber-power.com | Software Since
>> '88 siteware.com | Contact: darcy at siteware.com | 613-563-3634 by
>> appointment | Canada N 45° 25'03.1" W 75° 42'21.4"
>>
>>
>>
>> _______________________________________________
>> Lab mailing list
>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>> 2. then email Lab at artengine.ca
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20130622/e11159c2/attachment.html>