[Lab] 3D Scans Repaired!

[James Allanson]

I have three free tools I use to fix meshes.  Netfabb Basic Studio, Meshlab
and Meshmixer.  Meshlab is open source, and all are free to use.


On Wed, Dec 19, 2012 at 10:55 PM, <bentfork at gmail.com> wrote:

> What tools and tricks did you use/learn to heal the meshes?
>
> And thanks for all the work!
>
> On 19 December 2012 00:02, Henri Kuschkowitz
> <henri.kuschkowitz at gmail.com> wrote:
> > that is wicked. thank you so much for cleaning them up. I will try my
> best to come out tomorrow, but I am pretty tied up this week.
> >
> >
> > Cheers,
> > Henri
> >
> > On 2012-12-18, at 9:54 PM, James Allanson wrote:
> >
> >> Hello,
> >>
> >> I've got scans cleaned up and ready for the following people.  Please
> email me and I will send you your scan.
> >> Britta
> >> Chris
> >> Darcy
> >> Devery
> >> Eric
> >> Henry
> >> JC
> >> Kirk
> >> Marinus
> >> Matthis
> >> Michael
> >> Pedro
> >> Rick
> >> Steve
> >> Tim
> >>
> >> You can have these scans 3D Printed, or you can view it in software on
> your computer (such as Meshlab).
> >>
> >> Assuming I don't get held back by freezing rain or winter storms, I'll
> be at Modlab tomorrow with all of these scans displayed on my tablet.
> >>
> >> Cheers,
> >> James
> >> _______________________________________________
> >> Lab mailing list
> >> Lab at artengine.ca
> >> http://artengine.ca/mailman/listinfo/lab
> >
> > _______________________________________________
> > Lab mailing list
> > Lab at artengine.ca
> > http://artengine.ca/mailman/listinfo/lab
>
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20130106/44719ae9/attachment.htm>