[Lab] International Maker Meetup on 3D Printing, Nov 15th

[Britta Evans-Fenton]

I could get it to finished a little early (10mins), and I'd invite them all
to join us too!  If you want to set up before the workshop you can as well.

Britta

On Fri, Nov 9, 2012 at 11:30 AM, Andrew Plumb <andrew at plumb.org> wrote:

> Hmm… Setup/teardown would be a bit of a mad-panick scramble, especially if
> they run overtime…
>
> How likely is it that they'll finish on time or even early?
>
> A.
>
> On 2012-11-09, at 10:41 AM, Britta Evans-Fenton wrote:
>
> Amazing Idea! There is a private workshop happening in there until 9pm.
> But as soon as 9pm hits we could do "An Evening of 3D Printing" for just a
> couple hours.  I'd be down!
>
> Britta
>
>
>
> On Fri, Nov 9, 2012 at 9:38 AM, Andrew Plumb <andrew at plumb.org> wrote:
>
>> Hey Everyone,
>>
>> This thing is happening next Thursday:
>>
>>
>> http://blog.makezine.com/2012/11/06/first-international-maker-meetup-on-3d-printing-nov-15/
>>
>> The Google Hang-Out component starts at 9pm.  Is M70 free and do you
>> think the in-room 'net link is stable enough and has enough bandwidth to
>> participate?
>>
>> If yes to all the above and there's interest, should we hold "An Evening
>> of 3D Printing" and bring in some machines and related 3D printed stuff?
>>
>> Andrew.
>>
>> --
>>
>> "The future is already here.  It's just not very evenly distributed" --
>> William Gibson
>>
>> Me: http://clothbot.com/wiki/
>>
>>
>>
>>
>> _______________________________________________
>> Lab mailing list
>> Lab at artengine.ca
>> http://artengine.ca/mailman/listinfo/lab
>>
>>
>
> --
>
> "The future is already here.  It's just not very evenly distributed" --
> William Gibson
>
> Me: http://clothbot.com/wiki/
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20121112/e794f7cc/attachment.htm>