[Lab] Laser Laser

[Andrew Plumb]

Air Assist is included (see http://www.epiloglaser.com/zing_techspecs.htm) we just need to hook up a compressor.

Andrew.

On 2011-07-06, at 11:32 AM, Andrew O'Malley wrote:

> I second the air assist, it makes a huge difference.
> 
> ao.
> 
> 
>> Message: 2
>> Date: Tue, 5 Jul 2011 16:46:22 -0400
>> From: Ryan Stec <ryanstec at artengine.ca>
>> Subject: Re: [Lab] Laser Laser
>> To: lab <lab at artengine.ca>
>> Message-ID: <AE719A21-918D-44F7-B748-C31AA817BEB7 at artengine.ca>
>> Content-Type: text/plain; charset=iso-8859-1
>> 
>> To our questions of air filtration/exhaust Michael from Engravers had these recommendations:
>> 
>> "you will need a 3/4 horse dust collector
>> http://www.busybeetools.com/products/D%7B47%7DCOLLECTOR-3%7B47%7D4HP-PORTALE-750-CFM-CSA.html
>> 
>> If you want a charcoal i suggest you make one. We can sell one but it is expensive with the talent you have there it would be easy to make one.
>> 
>> Halon would be the best If you use the cutting table and the air assist this greatly cuts down on the flaming"
>> 
>> 
>> 
>> 
>> ____________________________________________________________________
>> 
>> Ryan Stec
>> Artistic Director
>> Artengine
>> 2 Daly Ave.            Ottawa, ON
>> K1N 6E2                613.686.1941
>> 
>> Try your luck with Adrian G?llner at http://artengine.ca/shapeofluck
>> Read the Driving Creativity Blog at artengine.ca/blog
>> Follow us on Twitter @artengine
>> 
>> On 2011-07-05, at 4:28 PM, Paul & Andrea Mumby wrote:
>> 
>>> One question, what are the plans for exhaust from the system? And is the lab planning on getting a compressor to use with air assist?
>>> 
>>> - Paul
> 
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab

--

"The future is already here.  It's just not very evenly distributed" -- William Gibson

Me: http://clothbot.com/wiki/