[Lab] ideas for small spindle for small cnc

[Doug Bellinger]

I think a dremel flex shaft would be good for balsa cutting.  If you remove
the cap on the end, the thread could be used to mount it to the machine.
You then have all of the dremel collets available for bit holding.  This
would probably work for engraving too.  I doubt it would be rigid enough for
any metal work, but you might be able to cut some plastics or do pcb milling
with it too.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20110209/eb3c93fa/attachment.htm>