[Lab] grommets and stuff

[Tom Burns]

On the cheap I would just tape any sharp edges and maybe tape the wires near
that point as well.  duct tape, packing tape, electrical tape, any should
suffice.  Ugly but sufficient.

On Mon, Apr 11, 2011 at 7:19 AM, Darcy Whyte <darcy at siteware.com> wrote:

> I am making up project cabinets. In most cases I'll be soldering rather
> than using connectors.
>
> What to use for wire exits? Grommets? Where to get them?
>
> I'm just concerned about wear of the wires at the exit holes.
>
> Any other ideas?
>
> Is it okay to just get some rubber tubing, split it and glue it to the
> sharp edges?
>
>
>
>
>
>
>
>
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20110411/99d5761f/attachment.htm>