[Lab] Makerbot printed Makerbot

[Jean-Marc LeBlanc]

Would that cost much in ABS plastic?

Jean-Marc Le Blanc
---

"Do you pine for the nice days of Minix-1.1, when men were men and
wrote their own device drivers?" Linus Torvalds




On Tue, Jun 8, 2010 at 1:39 PM, Andrew O'Malley <aomalley at gmail.com> wrote:
> Some of you will probably get a kick out of this:
>
> http://hackaday.com/2010/06/05/3d-printed-makerbot/
>
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab
>