<br clear="all">Um, because water is involved, I'm a bit concerned about screwing through it. <div><div><div><br></div></div><div>Also, by doing something that interferes with the outside roundness of the jar, it might not roll on the tumbler.</div>
<div><br></div><div>I'm not dismissing it. It sounds better the more I think of it but it still requires the right solvent to seal it up...</div>
<br><br><div class="gmail_quote">On Sun, Jul 3, 2011 at 4:40 PM, mike Jans <span dir="ltr"><<a href="mailto:mjans@live.com">mjans@live.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
<div><div dir="ltr">
Do you think the jar is tough enough to screw through? If so, you could press the agitators against the inside of the drum and screw into them from the outside.<br><br><div><hr>From: <a href="mailto:darcy@siteware.com" target="_blank">darcy@siteware.com</a><br>
Date: Sun, 3 Jul 2011 13:24:09 -0400<br>To: <a href="mailto:lab@artengine.ca" target="_blank">lab@artengine.ca</a><br>Subject: [Lab] protein jar tumblers<div><div></div><div class="h5"><br><br><div><div>I finally found some empty plastic protein jars to use for my rock tumbling project. They are large (like a gallon) and they have a wide mouth. The plastic is very tough so I think they will be okay as rock tumblers. They may be made of vinyl I'm not sure. </div>
</div><br>
<div>Anyways, any ideas of how to install rubs inside them so the rocks don't just slide inside?</div><div><br></div><div>I'm just a little concerned that it will be hard to glue unless I can find the right solvent.</div>
<div><br></div><div>One thing I thought of is to add a disk underneath the lid. So when you go to add the lid (like a peanut jar lid), you first put down a disk as if it were a seal. The lid would go over top of this disk and hold it in place. </div>
<div><br></div><div>Then the disk could have some agitators attached to it so that as the assembly turns the agitators rotate inside the container and make sure the stones don't slide.</div><div><br></div><div>Any thoughts?</div>
<div><br></div><div><a href="http://mambohead.com/2011/06/rock-tumbler-first-run/" target="_blank">http://mambohead.com/2011/06/rock-tumbler-first-run/</a></div><div><br></div>
<br></div></div>_______________________________________________
Lab mailing list
<a href="mailto:Lab@artengine.ca" target="_blank">Lab@artengine.ca</a>
<a href="http://artengine.ca/mailman/listinfo/lab" target="_blank">http://artengine.ca/mailman/listinfo/lab</a></div> </div></div>
<br>_______________________________________________<br>
Lab mailing list<br>
<a href="mailto:Lab@artengine.ca">Lab@artengine.ca</a><br>
<a href="http://artengine.ca/mailman/listinfo/lab" target="_blank">http://artengine.ca/mailman/listinfo/lab</a><br>
<br></blockquote></div><br></div>