<div><div>Thanks for the note. That's what I'll do. I'll tape with electrical tape till I find a descent solution for all my project boxes. </div><div><br></div><div><br></div></div><br>
<br><br><div class="gmail_quote">On Mon, Apr 11, 2011 at 9:32 AM, Tom Burns <span dir="ltr"><<a href="mailto:tom.i.burns@gmail.com">tom.i.burns@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
On the cheap I would just tape any sharp edges and maybe tape the wires near that point as well. duct tape, packing tape, electrical tape, any should suffice. Ugly but sufficient.<div><br><div class="gmail_quote"><div>
<div>
</div><div class="h5">On Mon, Apr 11, 2011 at 7:19 AM, Darcy Whyte <span dir="ltr"><<a href="mailto:darcy@siteware.com" target="_blank">darcy@siteware.com</a>></span> wrote:<br>
</div></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div><div></div><div class="h5">I am making up project cabinets. In most cases I'll be soldering rather than using connectors. <div>
<br></div><div>
What to use for wire exits? Grommets? Where to get them?</div><div><br></div><div>I'm just concerned about wear of the wires at the exit holes. </div>
<div><br></div><div>Any other ideas? </div><div><br></div><div>Is it okay to just get some rubber tubing, split it and glue it to the sharp edges?</div><div><br clear="all"><br><div><div><br></div><div><br></div><div><br>
</div><div><br></div></div><br>
</div>
<br></div></div>_______________________________________________<br>
Lab mailing list<br>
<a href="mailto:Lab@artengine.ca" target="_blank">Lab@artengine.ca</a><br>
<a href="http://artengine.ca/mailman/listinfo/lab" target="_blank">http://artengine.ca/mailman/listinfo/lab</a><br>
<br></blockquote></div><br></div>
</blockquote></div><br>