I am making up project cabinets. In most cases I&#39;ll be soldering rather than using connectors.�<div><br></div><div>What to use for wire exits? Grommets? Where to get them?</div><div><br></div><div>I&#39;m just concerned about wear of the wires at the exit holes.�</div>

<div><br></div><div>Any other ideas?�</div><div><br></div><div>Is it okay to just get some rubber tubing, split it and glue it to the sharp edges?</div><div><br clear="all"><br><div><div><br></div><div><br></div><div><br>

</div><div><br></div></div><br>
</div>