Does a power supply with the following description easy to connect to CNC software and controller?<div><br></div><div>It says PWM TTL so I think that's what I need to run from EMC2 linux and parallel port.</div><div><br>
</div><div><span class="Apple-style-span" style="font-family: Arial, Helvetica, sans-serif; font-size: 15px; -webkit-border-horizontal-spacing: 28px; -webkit-border-vertical-spacing: 28px; "><ul><li>Input voltage: AC 220V+30 or AC 110V+20 (to be specified when placing order).</li>
<li>Maximum output voltage:DC25KV (40W;50W) / DC28KV (60W) / DC35KV (80W)</li><li>Maximum output current: DC20mA (40W;50W)/ DC23mA (60W) / DC28mA (80W)</li><li>Isolation Withstand voltage: Input-output, input-enclosure: AC2000V-10mA-60s; negative pole of output connected to enclosure.</li>
<li>Protection: with well-grounded enclosure, output circuit of power supply can be open for short time (but arc between positive pole and enclosure should be avoided).</li><li>Response time (from time of input being available to the output current being up to nominal value): ≤1ms.</li>
<li>TTL voltage level control: effective voltage level can be high or low through setting.</li><li>Protection switch: for detection of cooling water, to protect laser device; or activate with enclosure is opened.</li><li>
Laser power adjustment: (1) by adjusting the output current of power supply through resistor; (2) through PWM control (magnitude being TTL voltage level).</li><li>Environmental requirements: temperature (-10~ 40℃), relative humidity ≤85%.</li>
</ul></span></div>