[Lab] Laser not working
programming at artengine.ca
Mon Nov 17 11:51:16 EST 2014
I heard from another member who used it yesterday who had a similar issue.
Once he restarted the machine it seemed to help but still. Last time turned
out to be a loose connection *inside* the machine, so we'd have to take the
back off and see.
On Mon, Nov 17, 2014 at 11:35 AM, Andrew Szeto <andrew.szeto at outlook.com>
> Hey Folks,
> I dropped by last night and it appears to have the exact same issue it had
> previously. I am thinking whatever the fix was last time (new firmware?),
> should hopefully fix it this time too. If it's something that members can
> hopefully implement ourselves when it arises, that would be helpful.
> Thanks y'all!
> From: jweisberg at sympatico.ca
> To: lab at artengine.ca
> Date: Mon, 17 Nov 2014 11:29:54 -0500
> Subject: Re: [Lab] Laser not working
> For some reason the text of my previous message didn't show. Here it is.
> The home setting on the laser is not working properly. It seems set a few
> inches in from the back of the table, and the carriage is hitting the front
> stops as a result, when cutting larger pieces. I checked the manual and
> tried a few different user settings without success. May need to go into
> the configuration menu to reset X and Y.
> Also the duct w/fan to the left of the laser has fallen apart. I didn't
> have time or materials to fix it either.
> _______________________________________________ Lab mailing list 1.
> subscribe http://artengine.ca/mailman/listinfo/lab 2. then email
> Lab at artengine.ca to send your message to the list
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab