[Lab] Laser not working

Andrew Szeto andrew.szeto at outlook.com
Mon Nov 17 11:35:50 EST 2014


Hey Folks,
I dropped by last night and it appears to have the exact same issue it had previously. I am thinking whatever the fix was last time (new firmware?), should hopefully fix it this time too. If it's something that members can hopefully implement ourselves when it arises, that would be helpful.
Thanks y'all!
Andrew 

 


From: jweisberg at sympatico.ca
To: lab at artengine.ca
Date: Mon, 17 Nov 2014 11:29:54 -0500
Subject: Re: [Lab] Laser not working




For some reason the text of my previous message didn't show. Here it is.

Hi,The
 home setting on the laser is not working properly. It seems set a few 
inches in from the back of the table, and the carriage is hitting the 
‎front stops as a result, when cutting larger pieces. I checked the 
manual and tried a few different user settings without success. May need
 to go into the configuration menu to reset X and Y.Also the duct w/fan to the left of the laser has fallen apart. I didn't have time or materials to fix it either.John
 		 	   		  

_______________________________________________
Lab mailing list
1. subscribe http://artengine.ca/mailman/listinfo/lab
2. then email Lab at artengine.ca to send your message to the list 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20141117/a2baab0b/attachment.html>


More information about the Lab mailing list