[Lab] modlab tonight

Justin Slootsky justin at slootsky.org
Wed May 14 12:01:29 EDT 2014

I used the red one a bit over a month ago without issue (and a brief look last week showed it appeared ready to run - level the bed). Last week, the wood coloured one was missing its print head, not sure if it has been located or not. 

----- Original Message -----

| From: "Darcy Whyte" <darcy at inventorArtist.com>
| To: "lab" <lab at artengine.ca>
| Sent: Wednesday, May 14, 2014 11:42:41 AM
| Subject: [Lab] modlab tonight

| i was thinking of coming tonight to try the 3d printer.

| I looked at the Web site (and the new ones are not listed under equipment
| (also not listed in the reservation system). I looked for the instructions
| in the wiki as well but didn't find anything. Do we all independently
| research how to use it? Are they up and running? Come think of it, I recall
| parts dangling or something from one of them... What is the status of these
| machines?

| --
| Darcy Whyte

| Art+ inventorArtist.com | Aviation rubber-power.com
| Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)

| _______________________________________________
| Lab mailing list
| 1. subscribe http://artengine.ca/mailman/listinfo/lab
| 2. then email Lab at artengine.ca to send your message to the list
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20140514/bff5e1fe/attachment.html>

More information about the Lab mailing list