[Lab] sanding disk for iron?
jim.kiskis at gmail.com
Sun Jul 27 16:54:04 EDT 2014
Your basic sand paper will work use 100-120 grit if you are going for a super fine finish use wet dry paper of 1000 or more grit
Sent from my iPhone
> On Jul 27, 2014, at 11:34 AM, Darcy Whyte <darcy at inventorArtist.com> wrote:
> I want to remove some rust from some iron. I'm supposing there is a sanding disk I can add to my hand held drill? Is there a special kid for metal? can imagine it's rather hard on ordinary sanding disk?
> Darcy Whyte
> Art+ inventorArtist.com | Aviation rubber-power.com
> Contact: darcy at inventorArtist.com | 613-563-3634 by appointment (no text)
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab