[Lab] Water sensor for an arduino?
amos at polkaroo.net
Tue Apr 1 09:01:10 EDT 2014
If you need something quick and functional, a shop that sells alarm system
bits may have flood sensors. They have a little float that lifts and closes
a circuit. Even Rona or Home Depot likely have them.
Otherwise, a piece of Styrofoam pegged at one end and a tilt switch might
amos at polkaroo.net
On 31 Mar 2014 23:49, "Justin" <justin at slootsky.org> wrote:
> Awesome tips, thanks!
> On March 31, 2014 10:26:25 PM Jaime Yu <jaime.yu at gmail.com> wrote:
>> Sparkfun has some water level sensors which you could check out.
>> https://www.sparkfun.com/search/results?term=water+level. It looks like
>> their H20hNo! kit does exactly what you suggest so maybe you can gleam some
>> hints from their schematics. The distance between the 'nail sensors' will
>> have to be awfully close in so the voltage potential is enough so it can
>> cross the medium. Water isn't that great of a conductor and will probably
>> require some experimentation to get the distance right (ie: salty water is
>> much more conductive than distilled).
>> Jaime Yu
>> B.Eng in Computer Engineering, System Hardware
>> Software Developer III at Juniper Networks
>> $CV = "http://cv.jaimeyu.com"
>> $Blog = "http://ask.jaimeyu.com"
>> $Project = "http://www.capstone490.com"
>> $Linkedin = "https://www.linkedin.com/in/jaimeyu"
>> $GitHub = "https://github.com/jaimeyu"
>> On Mon, Mar 31, 2014 at 10:48 PM, Tom Burns <tom.i.burns at gmail.com>wrote:
>>> If that doesn't work, use two nails and a floating conductive ball to
>>> complete the circuit when the water raises.
>>> On Monday, March 31, 2014, Justin <justin at slootsky.org> wrote:
>>>> With spring comes flooding.
>>>> I have a pump, but it doesn't have an auto shutoff, and it shouldn't
>>>> run dry.
>>>> I have a powertail that I can use to turn the pump on and off, so now
>>>> all I need is a water sensor.
>>>> Would this be as simple as two nails in a board with wires attached to
>>>> the nails? Water is conductive, when the water completes the circuit, the
>>>> Arduino notices and turns on the pump.
>>>> Probably two water sensors, with the "on" sensor being above the "off"
>>>> sensor to prevent it from triggering on and off too fast.
>>>> Is anything wrong with my logic? Why won't this work? Do I need more
>>>> than wires to make a water level sensor?
>>>> Lab mailing list
>>>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>>>> 2. then email Lab at artengine.ca to send your message to the list
>>> Lab mailing list
>>> 1. subscribe http://artengine.ca/mailman/listinfo/lab
>>> 2. then email Lab at artengine.ca to send your message to the list
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca to send your message to the list
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab