[Lab] Router Table + Router
marinus at noweverywhere.ca
Sun Nov 24 12:59:40 EST 2013
Correction: I meant masonite
Interactive Multimedia Developer
On Sun, Nov 24, 2013 at 12:46 PM, Marinus Swanepoel <
marinuswanepoel at gmail.com> wrote:
> I would like to cut a few panels of 0.25" fiber board with a bevel of 21°.
> Where would I be able to access a router table, router, and router bit to
> make such a bevel?
> The panels will likely be about 5" square, and I would like to bevel 3
> edges. I will have about 20 to 40 panels. I do not expect that routing the
> edges would take very long.
> If anyone is able to help I will be very appreciative.
> Thank you
> Marinus Swanepoel
> Interactive Multimedia Developer
> Phone: 613-915-0027
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab