[Lab] FabFont, a Typeface for Lasercut Stencils (CC By-SA 3.0 licensed)
jason.cobill at gmail.com
Mon May 27 11:36:21 EDT 2013
That's a nice one! I like the modern, geometric lines.
Stencil fonts are pretty handy, and there's a few of them out there under
various licensing arrangements. Anyone looking for more could also check
There's a few in here with a lot of character.
(many of) which also come with open web font licenses.
Admittedly, many of these are stencil-like rather than functional stencils
- your mileage will vary.
On Mon, May 27, 2013 at 9:53 AM, Andrew Plumb <andrew at plumb.org> wrote:
> Just spotted this in my Feedly:
> It's CC By-SA 3.0 licensed so definitely one to install on the ArtEngine
> "The future is already here. It's just not very evenly distributed" --
> William Gibson
> Me: http://clothbot.com/wiki/
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab