[Lab] FabFont, a Typeface for Lasercut Stencils (CC By-SA 3.0 licensed)

[Henri Kuschkowitz]

that's a nice find!  thanks Andrew

Cheers,
Henri

On 2013-05-27, at 9:53 AM, Andrew Plumb <andrew at plumb.org> wrote:

> Just spotted this in my Feedly:
> 
> http://moderndevice.com/resources/fabfont-a-typeface-for-lasercut-stencils/
> 
> http://fablabjapan.org/recipe/recipe/fabfont/
> 
> It's CC By-SA 3.0 licensed so definitely one to install on the ArtEngine systems.
> 
> Andrew.
> 
> --
> 
> "The future is already here.  It's just not very evenly distributed" -- William Gibson
> 
> Me: http://clothbot.com/wiki/
> 
> 
> 
> _______________________________________________
> Lab mailing list
> 1. subscribe http://artengine.ca/mailman/listinfo/lab
> 2. then email Lab at artengine.ca

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20130527/3bba100c/attachment.html>