[Lab] Voxel factory filament change?

Dave Hunt dave at huntgang.com
Mon Dec 16 20:00:17 EST 2013


Try wiping down the tape with rubbing alcohol before printing.

 

 

From: Matt [mailto:matt at mbells.ca] 
Sent: Monday, December 16, 2013 6:44 PM
To: greg atcheson; lab at artengine.ca
Subject: Re: [Lab] Voxel factory filament change?

 

 

I've had good results with filament from ORD (http://ordsolutions.com). I
tried one from reprap and couldn't get it to work properly... haven't tried
Voxel factory, though...

 

Sent from my BlackBerry 10 smartphone.


From: greg atcheson

Sent: Monday, December 16, 2013 15:47

To: lab at artengine.ca

Subject: [Lab] Voxel factory filament change?

 

Anyone else use Voxel Factory to supply PLA filament for reprap printers? 

I ask because my most recent purchases from them seem to be from a different
supplier, and the "glowing green" in particular is very different. Much
chalkier white color, worst of all i can't get it to print right! I have
tried all the usual things when i have first layer problems but it still
comes out like icing and doesn't want to stick to fresh clean blue tape on a
level cold bed. 

Anyone else have issues or suggestions? Mostly wondering if anyone else
noticed the quality change and had to adapt. 

Thanks! 





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://artengine.ca/pipermail/lab/attachments/20131216/37b9c89d/attachment-0001.html>


More information about the Lab mailing list