[Lab] International Maker Meetup on 3D Printing, Nov 15th
steve at envirolaser.com
Fri Nov 9 12:17:40 EST 2012
Corey (prez @ Envirolaser) said that we can use Envirolaser's office for the
IMM for 3D Printing.
Just let me know for certain so I can make arrangements for our IT guy to
set up a separate wireless network.
steve at envirolaser.com 8
P Please consider our environment before printing this mail.
From: lab-bounces at artengine.ca [mailto:lab-bounces at artengine.ca]On Behalf
Of Andrew Plumb
Sent: Friday, November 09, 2012 11:31 AM
To: Britta Evans-Fenton
Subject: Re: [Lab] International Maker Meetup on 3D Printing, Nov 15th
Hmm… Setup/teardown would be a bit of a mad-panick scramble, especially if
they run overtime…
How likely is it that they'll finish on time or even early?
On 2012-11-09, at 10:41 AM, Britta Evans-Fenton wrote:
Amazing Idea! There is a private workshop happening in there until 9pm.
But as soon as 9pm hits we could do "An Evening of 3D Printing" for just a
couple hours. I'd be down!
On Fri, Nov 9, 2012 at 9:38 AM, Andrew Plumb <andrew at plumb.org> wrote:
This thing is happening next Thursday:
The Google Hang-Out component starts at 9pm. Is M70 free and do you
think the in-room 'net link is stable enough and has enough bandwidth to
If yes to all the above and there's interest, should we hold "An
Evening of 3D Printing" and bring in some machines and related 3D printed
"The future is already here. It's just not very evenly
distributed" -- William Gibson
Lab mailing list
Lab at artengine.ca
"The future is already here. It's just not very evenly distributed" --
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Lab