[Lab] PCB Etching and next meeting

Andrew Plumb andrew at plumb.org
Mon May 17 16:08:45 EDT 2010

If your chuck can hold them, Lee Valley carries a selection of small drill bit sizes:


On 2010-05-17, at 3:58 PM, Nicholas Renaud wrote:

> I'm fairly experienced with the ferric chloride and have a drill press
> for drilling holes.  I'm wondering if anyone knows where one can get a
> good thin carbide drill bit around town though.
> Nick
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab


"The future is already here.  It's just not very evenly distributed" -- William Gibson

Me: http://clothbot.com/wiki/

More information about the Lab mailing list