[Lab] Makerbot printed Makerbot

[Andrew Plumb]

Yup.  It's more of a "just because you can" project than practical.

You could print many mini-Mendels in the same amount of time it would take to print one of those.

Andrew.

On 2010-06-08, at 4:44 PM, Jean-Marc LeBlanc wrote:

> Would that cost much in ABS plastic?
> 
> Jean-Marc Le Blanc
> ---
> 
> "Do you pine for the nice days of Minix-1.1, when men were men and
> wrote their own device drivers?" Linus Torvalds
> 
> 
> 
> 
> On Tue, Jun 8, 2010 at 1:39 PM, Andrew O'Malley <aomalley at gmail.com> wrote:
>> Some of you will probably get a kick out of this:
>> 
>> http://hackaday.com/2010/06/05/3d-printed-makerbot/
>> 
>> _______________________________________________
>> Lab mailing list
>> Lab at artengine.ca
>> http://artengine.ca/mailman/listinfo/lab
>> 
> 
> _______________________________________________
> Lab mailing list
> Lab at artengine.ca
> http://artengine.ca/mailman/listinfo/lab

--

"The future is already here.  It's just not very evenly distributed" -- William Gibson

Me: http://clothbot.com/wiki/